Enhance Safety: Videosystem Rear View Camera Backup Camera Replacement for Chevy Express GMC Savana Cargo Van Transporter/Savana Explorer 2003-2018 Year Third Brake Light Review

everything is fine, the price and appearance, but the description of the installation may be different for everyone. - Connected two wires for a brake light, it doesn't match, but hardwire - "silicone" black / insert long wire from camera to front panel - "tail tail" black to ground on any screw on chassis, red on each 12V and Yellow RCA to REAR CAM on the back of the radio - now the part that doesn't explain it: Connect the wire from the reverse light to the purple wire on the back of the…

Installation was easy enough. The master brake light connector was wrong, but a few simple wires and everything works. Your situation may be different, but both the video cable on the camera and the main unit were female. Therefore, when you order this camera, BUY an RCA MALE TO MALE ADAPTER. In general, the quality of the camera is quite decent.

Picture quality and workmanship are really good. Angle and installation position are almost perfect. The only reason I'm taking the sprocket off is a bad seal and the wrong brake light power connector. I solved the weather seal problem with black silicone. I solved the wiring by removing the connectors and hooking up a brake light. If the product had come with a foam/rubber gasket and straight plug cord it would have received 5 stars.

After installation I liked the result a lot. The grid lines tell me if I have a backup where to open my back doors. I no longer have to get out of the van to see how far I can get out. What confuses me is that the wire to connect to the reverse light wire is on the front of the wiring harness. As a result I had to run a camera cable to the front of the van and then another cable to the back of the van to connect to the reverse light so the camera and monitor know when to turn on. If I knew what

Bought a radio with backup camera (master) and broke the camera trying to turn it over because it was upside down. That was before I knew there was an invert camera setting. I was trying to install this camera on my Chevrolet Express bumper. It wasn't the best choice for a camera position. It has an adjustable shaft and fits right where the OE center brake light was. The wiring harness that comes with the flashlight is not compatible with the original wiring harness. But it's only 12v and…