📻 Black Radio Antenna Base Bezel Mount Replacement for Toyota Sienna 2011-2014 - Upgrade for Enhanced SEO Review

Perfect fit for 2011 Toyota Sienna. It was a bit fiddly to put on at first, but with a little soap everything went smoothly. Has been working without problems for a few months

The bezel looked like the original but was slightly smaller at the flange and it was almost impossible to get into the hole. Had to use soap before it slides onto the antenna. Appearances can sometimes be deceiving.

This decorative case could not be attached, not as described. Spent a few more euros and got the original. We had to spend $40 to put it on, and with only a few extra dollars for a Toyota, we put it on ourselves in minutes.

Costs about 10 times what I expected from a piece of rubber and doesn't fit very well. I've been trying for a long time to insert the rubber edge into the hole on the wing, but to no avail. I can omit it out of laziness, but it doesn't go well with my 2012 Toyota Sienna.

Looks great and OEM. Found this a little difficult to install. Super tight fit and used lube spray to help. I ended up using a suitably threaded screw to screw it flush into the base, loosening the screw and attaching the mast.

Not the easiest of installs but with a few tricks I got it working properly - spray some soapy water to lubricate - though You have a hair dryer or heat gun - heat it slightly to make it warm and pliable. - Once I put it in, I used needle nose pliers to push the rubber sideways into the hole and it stays in place.