🛴 Razor Scooter Replacement Handlebar Grips - Premium Foam Grip for Enhanced Comfort and Control Review

I fitted these grips to a scooter that originally came with rubber/silicone grips that wore out in less than a year. I cut them off and after a few minutes replaced them with foam pads. They were installed dry without tools such as hairspray or heat. The foam grips are more comfortable and the hard rubber caps on the ends should withstand accidental drops to the ground better than older grips.

We needed to replace the handles on our maxi scooter. They are very easy to assemble and fit. They also feel a lot better than the originals. Things to note: decorative caps don't fit (we're not embarrassed); I used warm soapy water to make it easy to slide over the handles. At first I didn't think they would stay in place. However, once dried, they held onto the pole and did not move. Hope that helps.

These grips have only been in use for a few weeks but so far they are great. The instructions indicate the grips to follow to get a strong and secure grip on the scooter. But it was easy enough for my 12 year old daughter to put them on by following the instructions. They are nice and soft for a comfortable grip and I hope they last a long time. But for the very cheap price of the grips and the original quality I would definitely buy again!

My 8 year old was upset when one of the handles on his roller razor came loose. I bought these to replace and they've been great so far! If you have a Razor brand scooter you may need to remove the plastic end caps and cut the elastic cord to remove the existing ones. Then, be sure to follow the included instructions to attach it. I did it exactly as the instructions said and they stayed in place and worked great! The only issue we had was the plugs stuck out a couple of times. However, a few…