🔧 HVAC Blower Motor Resistor 3F2Z-18591-AA YH-1715 for Ford Expedition, Escape, F150, F250, F350 Super Duty, Mustang, Lincoln Mark LT, Mercury Mariner Review

Works. Sent quickly. Would order again. Can't say how long it lasts. but for the price i can fit 5 of these for the price of one oem part.

The product is original - arrived on time and at the right price. I installed a resistor and the fan in the car works as it should - great thing.

Replaced the electric fan resistor in the 2011 Escape. The fan worked only at high speeds. It was easy to install and now the fan motor runs at all speeds.

Product is still OK Also good value for money. Replacing a part is difficult for a person with large hands and an inability to flex the hand, fingers, and arm. Not a part defect, but a Ford design defect.

Good details, good fit and good performance. The exchange lasted ten to minutes. Works fine and I have all four fan settings back, not just high. I replaced this part on my 2011 Escape about two years ago. A common problem with escape. Simple inexpensive repair.

This is the second time I have had to change this part. I had to change 3 years ago. Not sure why, but when it's running I lose both low speeds and there's a melted spot on the drag. The parts replacement takes about 5 minutes. After replacing the part, everything works perfectly again.

Don't waste your money on this low quality product. Less than a month later, only the highest setting (direct switch) still works. The photo shows where the circuit burned down. Now I have to spend my time installing another one. Going forward I'll stick with the motorcraft part.

Great item, fixed my non working fan setup and was quick and easy to replace. compare with the new one. When you want to put the new one in, a couple of plastic tabs need to be lined up with the holes for it to seat properly. There are spots in this part where you can easily drill the holes you need to be blank and I had to drill two. Before I bore them out, the new part ran into these lugs and there was no way it would sit flat or screw in properly. I just wanted to leave this note for anyone…

The 3rd speed in my standard resistor stopped working so I bought this replacement. It worked fine for six months, then 2nd gear stopped working. Three months later, the 3rd gear stopped working. Within 10 months of purchase, all 4 fan speeds stopped working. I bought another one (obviously after 10 months out of warranty) hoping that the one I bought 10 months earlier just had no luck. However, after only 10 months of use, fan speeds 1-3 are again not working and I expect the 4th to fail…