💪 Enhance your Riveting Efficiency with the Rivet Nut Gun Tip & Accessories (10-241pcs)! Review

My buddy broke a spot welded nut in the floor pan of his Subarus driveshaft center bearing. There was absolutely no way to tighten it with a nut and bolt as the spot welded nut was inside the floor pan's hollow section and would require some serious cutting or welding. My Cornwell nut kit only fits the m8 so I noticed this part looked fairly familiar and ordered it. This is the exact same part but also upgraded to M10. This and a large set of full fasteners allowed the driveshaft to be…

It was bad enough that my project had to wait a week for the tool, but that was my decision. I had other aspects to work on. The tool arrived on time and in perfect condition. I was sure I would be careful not to twist or pull it too hard since it's such a small tip. It doesn't matter, the tip of the third nut broke off in the thread. He didn't even lengthen or damage the thread. Obviously the tool was outdated as it was fragile and broken. If you decide to buy this product, take two, three or…

Good replacement. Didn't feel any different than what I had with the My Astro 1442. People who complain of a broken mandrel are either careless in unscrewing after riveting or don't have their head in the correct position for the size they are working with. If you use a smaller screw such as For example, when using M5 or 10-24, your head should be set as low as possible so that the mandrel does not pull over the compressed portion of the rivet nut at the end of the setting stroke. . You can…