🚜 Rough Country Rear Coil Spring Correction Plates for 1997-2006 Wrangler TJ - Model 1141 Review

This product is designed and manufactured with precision from durable materials. Installation instructions are clear and concise, with the exception of removing the stabilizer bar, which made installation a lot easier. As another post commented, the fender cap is a must. I added these caps to prevent destroying the fender rubbers.

Very good quality. The instructions are simple and very easy to follow. It is required to drill a 13/32 hole in the coil bucket. The hardest part was getting the spool out. The easiest way to remove the coil is to disconnect the shock and place a jack under the opposite side. If you lift the opposite side, the side you're working on will fall down. Replacing the coil is not easy either. I ended up VERY GENTLELY squeezing the coil with a vise and pressing with wire. Much luck!

These work well to straighten out the rear spring significantly. The only downside is the large hole at the top where the bumper hits when the spring compresses. In my humble opinion they should have welded the top and recommended increasing the height of the fender. I don't think a typical fender will fit the hole perfectly, but it will hit the edges and crack your fender. In my case I have a 4" riser and I cut my upper bumper to the same size as the raised height of the adjuster which is…

I did a lot of searching to see if this would increase the ride height as it is not listed in the description. The reviews said there is no increase, maybe 3/8 inch. When I installed it, it increased the ride height by 1 1/2 inches in the rear wheel arch. Much more than I wanted with short control levers. Attention buyers. In addition, the central section is an open tube. My fender hit right on the edge and would rip to pieces, I use fenders when steering. I welded on a plate for a flat bearing

First off I can't stress enough how much better my Jeep drives and handles. If you have a lift of any kind with longer springs, this is a must. It corrects spring angles and rear suspension working geometry with a simple fix. RC has created another great product that is well designed and easy to install. 1 1/2 to a maximum of 2 hours. Two small problems: RC keeps improving their products and has really grown into a good company. I wish they had a shipping deal so they could offer free shipping.