🚙 Rugged Ridge 11230.01 Euro Guard Kit for 97-06 Jeep Wrangler TJ/LJ - Headlight Protection in Black Review

Easy to install, be careful which side is which as the left and right screws are positioned differently. Goes well with the black bezel!

These covers fit my 2000 Wrangler Sport perfectly. Just make sure you have a long screwdriver to install them as you will have to go over the guardrail to get the screws right back. Each installation takes about 1 minute.

looks great just like I thought. I will say however that you do need to put some effort into screwing them in, the parts that stick out for the screws are at a slightly odd angle and it takes a lot of effort to get them to flex the way they are Be careful not to tear the screws apart

Do you happen to sell sets that are made differently? They absolutely do not match my '97 Jeep TJ. However, there are people here who claim they are perfect for their TJ? I can only align the bottom bracket, the top two don't get close to the other bezel mounting screws, and even if they did, the tabs are so far forward that I couldn't push them back. WHAT?

Purchased with black Rugged Ridge frames. You look great. The quality is better than the tail light kit I bought. Easy to install but it was interesting to try and find a way to get the screwdriver to tighten the screws. My only issue with this product and frames was that there was no hardware included. While I know I could just use standard screws (which I did), this item is black and the stock hardware is silver. Black hardware would be nice. In the end I just painted the screw heads.

Great looks. Two nice touches that deserve a five-star rating: (1) include the black top screws, and (2) improve the fit a bit - the top tabs stick out too much in the front and I had to carefully bend all three mounting tabs a little bit outside to get the brackets within 1/8 inch of the faceplate. Bending the lugs actually loosened the protruding lugs somewhat, but the top ones are still too noticeable and can be reduced by 1/16th of an inch to look much better. I tested fit on both the…

Let me start by saying that this product was not easy to install. Other reviewers say they had no problems and I consider them lucky because I spent about an hour figuring out how to put them on. The problem was that where you attach the guard to the bezel with factory screws, the actual headlight guard gets in the way, making it very difficult to screw in. After many tries I went to a hardware store and bought a flexible bit holder. The flexible bit holder makes it MUCH easier to tighten the…