🔧 Runleader Digital Hour Meter: Maintenance Reminder for ZTR Lawn Mower, Tractor, Generator, Golf Cart, Marine, ATV, Gas Powered Equipment - 5V to 60V DC Review

Just purchased Toro 75754 Time Cutter Zero Turn, it came with no hour meter. You can get one for like $70 or do what I did and get it from the guy I made. Installation took less than 5 minutes, works great. As you can see, it looks like a factory setting. It displays the hours of operation and requires an oil change every 50 hours. Yes, I recommend this seller and this product.

I would show pictures but there is no point, this hour meter is perfect for my Timecutter 75750. It fits on the factory cable attached to the other wires. All you have to do is file the hole a bit and it will fit right in. It works the same as a torometer, it only counts hours while you are on the seat, just like a torometer. Buy this instead of a torometer for $70. Actually, Toro had to put it there for a $3,100 mower, but we won't get into that.

Quick install on my Toro SS 4225 74721. There was already a cut out on the frame behind the seat. Only downside is you have to rotate your head out of the seat to see the display to read as it only lights up when you are sitting in the chair. There is no corresponding cutout on the console where the throttle lever is located. Just a small, maybe 3/8 round hole that I don't know what you think goes in there. I can easily move it onto the console with a dremel cutter. That is, if I manage to…

loved it when it arrived. As expected, I had to file a small hole in the car and everything worked fine at first. Until seven o'clock mostly dry weather without problems. However, yesterday I drove my truck at high speed through a typical Florida storm for two hours with my headlights and wipers on and a few more hours of the storm after I got home. Unfortunately it looks like water got in and today the screen just went crazy. sad but true. Now I have to get another meter. This one is probably…

I recently bought a used Craftsman GT5000 lawn tractor and 42 inch wide snow blower. The tractor didn't have an hour meter so I bought this and it fits my tractor perfectly. A mounting hole was already molded into the dashboard, so installing this unit was very easy. I found a +12 volt switching power supply and made a red +12 volt wire and a black negative wire to turn on the hour meter when the key is on. It works as advertised and allows me to keep track of oil changes and other service…

I just bought a new $4000 Toro Zero Turn and it didn't have an hour meter. So I bought this from Revain for $16. Toro wanted $81. What? The installation literally took 5 minutes. Toro has a pre-punched hole that you cut with a utility knife. Under the panel there is a wiring harness to which a connector for connecting an hour meter is taped with black electrical tape. Cut the tape and it connects directly to the hour meter. Screw in the bezel with a screw and push the hour meter until it clicks

I asked about the hour meter when I bought the Toro Timecutter 2020 Zero Turn Mower. I was told that it cannot be installed. I found a video of the installation and found that the lawn mower comes with a cord to plug in. At first I couldn't find the hole for the counter, but I found that it was covered with a sticker that showed engine RPM. I thought that over $60 seemed high for a watch counter, but then I found this one. It's very similar to the "OEM" meter for a third of the price and…

Perfect for my Husqvarna YT18542 lawnmower. The folks at Husqvarna thought my particular model didn't need an hour meter, but the hood and dash and wiring harness were the same as the models that included one. So it was easy to match the hour meter size to Revain's using the specifications of the next most expensive tractor model. Then, when I reached behind the dash and looked for the only loose connector (black and blue wires), I could see which orientation the connector was in. bottom line…