RV Designer E222 Plastic Hardware Review

I ordered this because it was an exact replacement for my trailer. I received a pen that does not look like the picture. The holes will match, but I prefer to use the same one if possible. I pay special attention to the details I wear.

Well made, strong, easy to assemble. It didn't match the one I already had installed, but that's okay. I would like every manufacturer to fit them from the factory. It's so helpful, especially as you get older and not as stable as you used to be.

This is a really good pen for the price. I installed a couple of these on my van, one on the side door and the other on the bulkhead. So far they are holding up and looking good too. I'm a little worried because it's 100 percent plastic (no metal reinforcement) so I'm not sure how it will perform in the long run, especially in very cold weather where the plastic can become brittle, but so far so Well. I also put washers under the screw heads to keep the screws from cutting into the plastic when

BUYER ATTENTION - This is absolute RUBBISH! I bought a couple of these to fit in the back doors of my Sprinter van. I purchased these specific grab rails because the item in the picture looked exactly like the grab rail that was installed on my caravan. If the items arrived and were actually what was in my trailer they would work great. However, what I actually received did not look like the photo (apart from being black) and therefore not what I was hoping for. In fact, it's a CHEAP thin…