Sea-Dog 412601-1 Manual Windshield Wiper: Reliable and Efficient Wiper for Clearer Vision Review

Luckily I bought this to replace the one that was vibrating apart and the winch was lost. It should come with a bracket that attaches to the mechanism. The bracket acts as a shelf to hold the wiper in its original position. It would have been worse without the mount.

This wiper is suitable for municipalities that need it for marking. But the installation method sucks. You'll have to drill through the windshield itself, so if you later want to lower the top half you'll need to remove the wiper. But for the price, it's hard to beat.

This is the worst product ever made! It's such rubbish to be honest, I wasn't expecting much but it's lower than everyone expected. The arm is as thick as a soda can. The blade is a 12 inch piece of hard thin rubber. The hand would be more difficult to replace the blade as it is an old style bayonet.

I have this for my 2020 Polaris General XP 4 with sXs windshield front glass and it is the perfect wiper. Therefore. I tried other wipers but they were all too long. This one fits perfectly and is actually quite adjustable so you can make it fit.

I bought this unit because the previous wiper (same brand) lost the special round mounting nut within two weeks. It vibrates slightly and Home Depot doesn't have those special nuts. So when assembling, don't forget to add some sealant to this round ball nut. Other than that, it's a decent quality product.

I saw some bad reviews about this product but decided to give it a try. My conclusion is that it's well made and if anything goes wrong it's user error. I see no reason why this shouldn't provide good service. The handle is metal and should not fail when properly assembled. I will order more for the other side of the windshield.

I need this wiper to check off. Where I live it is a requirement to legalize the use of a golf cart on the street. It serves that purpose well. In terms of functionality, it does a less than stellar job as a janitor. If you have to rely on it to see, you could be in trouble. It installs to the windshield of a Plexiglas golf cart in minutes using a 1/2" spade to drill a clean hole.

It looks pretty poor, but a cheaper alternative is sufficient for a short-term replacement. drilled a 1/2" hole in the windshield frame, put the handle shaft through the windshield and tightened it. Looked fine until I started tightening the wiper arm onto the shaft. Tighten just enough to keep it from slipping on the shaft. Many thanks to Revain for the hassle-free return!

Well made quality product. I installed one on the windshield of my golf cart. So I can quickly run my finger over the windshield. I think I'm the only resident of The Villages in Florida (tens of thousands of golf carts) with one of them. If you decide to install it I've found that using a soldering iron to drill a hole in the windshield works well (no cracks). You can clean out the hole with a small round file or a Dremel tool.