🔌 Sewell Ghost Wire Termination Block: Enhancing Cable Management and Organization Review

Great product, easy to use but thin film of rubber on copper wires going into appliance ports, you will have to use isopropyl alcohol to remove it! The video shows that you just press the copper end and twist your index finger up and it just pops off. Not correct! Not correct! This is a film of rubber glue or glue gun glue. Save yourself 30 minutes of agony.

I have two problems with these terminators - 1) where are the adhesive strips to stick them to the wall? and 2) did the manufacturer clip their products, tape them to the wall to see how they behave and how they look? There is a 2mm gap between the wall and the phantom wire due to a piece of plastic. Should the wire not be glued as flat as possible 😡

I bought these to run speaker cables under my carpet and they work great. Two complaints. Conflicting instructions on how many times conductors must be folded before they are inserted into a terminal block. I would only fold once - otherwise too thick to adjust. The second point of criticism is the tiny screws for inserting the speaker cables. My 16 gauge speaker wire was too thick, it took me quite a bit of effort to get it to work. I think the screws need to be bigger to allow for larger…