Signal Dynamics Corp 01008 Add-On Light Kits Review

I mean this unit doesn't get hot. Other resistors for LED lamps get very hot in a very short time. After turning on the emergency lights for five minutes, it stayed cool. Would have been five stars but the faucet connections were terrible.

Bought 2 of these, one for the front and one for the rear turn signal kit. The product works fine. There's a second or two of rapid flashing when I first use the signals after starting the bike, but after that it's slow and steady as it should be. Inexpensive and works wonders, it doesn't get any better.

Purchased to balance the load when I switch to LEDs on my 2006 Kawasaki Vulcan which had Hyperflash front and rear iBrightstar Super Bright LEDs. I installed a Signal Dynamic Load Balancer built under the rear fender and headlight bowl for front and rear signals and now it works great!

I bought a built in tail light for $30 (work, stop, direction of travel) and figured I could just clip it on and go but obviously not as my bike is 20 years old . years and no longer has LEDs. So I had to buy this product. I installed it under the seat, grounded it to the frame with the ground clip, and routed two wires in the back (in the fender) so I didn't have to connect them to the stock wiring harness. Inside the light box I used the connectors that came with this product to connect the…