🚦 Enhanced Youxmoto 3rd Brake Light for 2007-2013 Chevy Silverado/GMC Sierra 1500 2500HD 3500HD - LED High Mount Stop Light Cargo Light 25890530 (Chrome Housing/Red Lens) Review

The light is much better than LEDs and comes with the whole case (mine cracked from time to time and got water in). Easy to put on and install. Two screws and a simple clip for the light cord.

Fits well and works perfectly. I would have liked it to be a bit brighter, but with my tinted LED taillights I'm basically going to achieve a uniform look and that completes the look. Brighter LEDs would make this a 5 star rating. Maybe next time?

My factory 3rd headlight started leaking water through the gasket causing water to seep into my truck and all over the headliner. This 3rd replacement headlamp was very easy to install and worked as expected for less than half the cost of a dealer headlamp.

It works but looks cheap where the reflector chrome looks flimsy and crumpled. It just looks and feels cheap. The LEDs are fairly bright, but not as bright as a rear brake light should be. The light in the trunk is not as bright as the factory light, but it works. I highly doubt this is DOT approved.

I installed this on my 2007 GMC Sierra. Perfect fit, comes with 3m tape on both sides. I wiped down the truck seat and headlight with rubbing alcohol. Then I attached the light first. Save your two screws as you won't get new ones. There are also small rubber buffers on the screw. UPDATE; A few months later and lots of rainy weather, no leaks and working fine.

. My old third brake light lens cracked allowing water to get into the housing and eventually soil the headliner. This replacement item was inexpensive and easy to install in place of my old broken flashlight. The kit came with a new gasket and rubber washers for the screws. It seems well done. It gives my truck a more modern look with LEDs instead of incandescent bulbs. The light was only installed today so we'll see how it holds up, but so far so good!

You get what you pay for. I had several problems. First, the screw holes were off-center, so he didn't want to go straight. Second, the case is thick, like a factory case, but the finish on the reflectors that house the LEDs looks terrible. These are real rough/jagged edges. Third, and this annoys me the most, my truck headlights don't work. I can reconnect my factory lights and they work fine, but on this new one they don't work at all. The only reason I'm keeping this new one on my truck is…