Solid Brass 2 Way Garden Hose Splitter - Easy To Open & Comfort Grip | Riemex Y Valve Connector Review

Bought this splitter to have a hose to wash down the back yard and one to water my plants. Splitter is well made and zero leaks good product.

Couldn't source these locally. All i could find were cheap plastic or chrome-plated pot metal ones. So glad I found these high quality brass fittings. I have four outdoor faucets with two hoses on each one, and these easily allow me to switch the water to the correct hose without having to unscrew one to use the other.

I have had this for about 2 years, and it has not held up any better than an inexpensive plastic one. Leaks terrible, and knobs are very hard to turn.

Attacked to faucet,turned tap on, water squirted everywhere. Checked and washer was in. I then used washer tape around faucet and reattached.

This is a very solid piece of hose gear. Small but really all you need. Replace the gaskets as needed and this little thing will last a lifetime!

The primary male thread has a sub thread into the unit and will come apart dropping the internal ball that turns. The fitting should be a solid piece but it is not.

The black ring inside was too loose it couldn’t hold in the water. We tried the extras that came with it and none of them worked. It is going back. Don’t know why it had such high ratings.

I used this product to attach both my washing machine and reverse osmosis unit to the cold water in my laundry room and it was easy to install and works great with no leaks.

So far, this is a great item. A little concerned that the plastic handles may not last long in the AZ sun but hopeful! That's my feedback.

I bought two of these and set them up this past week. They work great but i had one small problem that i wanted to point out. The end cap for the two split sections can unscrew, allowing the ball stop to come out. I had tightened a hose down onto one of the ends, used it and then took that hose back off. When i did this, the end cap of that section actually unscrewed with the hose. it was a pain to get the end piece back out of the hose and then to get the ball back into the socket correctly to