🔊 Premium Rhodium-Plated Copper Speaker Spade Connectors with Screw Locking - Enhance Your DIY Speaker Wire Setup (Pack of 4) Review

This set of paddles is only enough for ONE SIDE (one channel), the bot is even enough for a pair of speaker wires. Complete Divorce! For this price there should be at least one complete set. WOW.

These clamps were easy to fit with a small Allen key. There was only one problem! They transparently covered these terminals and made them powerful. It didn't work to begin with and had to sand the surface layer to make it work. :(Also they look and feel good. I also added an extra case to mine.

Needed something that couldn't handle 90A surges and stayed cool at 50A DC and that seems to be doing its job well. I only let it run for a couple of hours and managed to keep the average current at around 5A, but it handled power surges well. It connects to my car battery to power a 3kW inverter.

This product has two major problems. 1. It has a clear coating that completely eliminates continuity. There is no connection at all. You must remove the clear coat for them to work. 2. There is no copper under the plating. They are brass. This is clearly false advertising. They are beautiful but it is a pity that they are not as in the description.

do not buy! Not copper, there is a "clear coating" and then a copper colored coating over the brass they made it from. I tested them before use and they were unreadable due to the coating! I took off this cover and went down and lo and behold? A thin layer of copper came loose and I found brass! Don't waste your time and money! Do not buy!

They are easy to install. You will need a very small hex wrench (hex wrench) to tighten them. 2mm I think. Note that the hole is stepped, which can make it easier to use on binding posts of different sizes. However, they were a bit too big to ground my amp. If you've never worked with heat shrink tubing before and don't have a blow dryer, just use a blow dryer (close-range high heat).

Excellent connections. Easy to connect. You need a very small Allen key. One thing I would like to change a bit is the angle of the curvature, which I couldn't connect to the bottom posts of my speakers. There was insufficient clearance between the clamped fork and the bend. It was slightly longer than the stem/fork, this would have helped connect to any bars. It doesn't matter if your speakers' messages are delayed enough. My speakers are Yamaha NS777.

The overall quality, workmanship and attention to detail of these cable lugs is absolutely outstanding! I would have no problem comparing them to top brands like Furutech or Viablue for a fraction of the price. I went with pure copper instead of rhodium plated copper blades for about $7 less which is an absolute steal. These jacks can be installed on 4-way speaker wire and don't feel remotely out of place in my opinion. A++++

These spades are very solid, slightly larger than expected. Ideal for large cables. Provides a strong connection when you have the correct connector type on your amplifier and speakers. Note I've achieved a tighter fit by adding a bit of torque to the vane by rotating it in the same direction while rotating to tighten the terminal (this makes it difficult to get a perfectly aligned look, although it takes a few tries). I wish he had brought longer heat shrink tubing. I had to run to my local…