Header banner
Revain logoHome Page
๐Ÿ”ฉ schedule socket union fitting for spears logo

๐Ÿ”ฉ Schedule Socket Union Fitting for Spears Review

3

ยท

Poor

Revainrating 2.5 out of 5ย ย 
Ratingย 
2.7
๐Ÿ”ง Fittings, ๐Ÿšฐ Hydraulics, Pneumatics & Plumbing

View on AmazonView on ะฏM

Media

(3)
img 1 attached to ๐Ÿ”ฉ Schedule Socket Union Fitting for Spears
img 2 attached to ๐Ÿ”ฉ Schedule Socket Union Fitting for Spears
img 3 attached to ๐Ÿ”ฉ Schedule Socket Union Fitting for Spears

Description of ๐Ÿ”ฉ Schedule Socket Union Fitting for Spears

Union fitting for connecting and disconnecting two pipes more easily than with couplings. Socket openings on both ends for connecting two male pipes. PVC for strength and resistance to chemicals and corrosion, and an EPDM seal for resistance to oil, water, and some solvents. Maximum operating temperature of 140 degrees F. Meets ASTM D1784 and D2467 standards for quality assurance, and certified by NSF International for potable water service.

Reviews

Global ratings 3
  • 5
    0
  • 4
    1
  • 3
    1
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

Spears, good value for money.

I used each side of this union to close and winterize my sprinkler system, I had to use those original spears for a unique thread. Shipping was in a reasonable time and was better than driving to the nearest dealer.

Pros
  • Union fitting makes joining and disconnecting two pipes easier than with couplers
Cons
  • Unbelievable price

Revainrating 4 out of 5

CLICK and SWITCH! FALSE ADVERTISING! Zero stars!

WARNING! Advertised as 'Spears' (top of the range) but comes with a Charlotte fit and fits in a 'Spears' bag. Because of this, the previous buyer was unable to "mix and match" their existing Spears fitting. I'm desperate so I'll use this, but don't buy from these guys if you need Spears.

Pros
  • Maximum operating temperature 140 degrees Fahrenheit
Cons
  • write later

Revainrating 3 out of 5

Good to know: Fittings

I bought this nipple hoping it would fit an older existing nipple. The original fitting has a flat/socket on the male side, O-rings (two of them in the old fitting) on the male side. This fitting is opposite. The sealing ring is mounted on the inside, the flat mating surface is on the connector side. The three stars are not for this installation issue, but because the o-ring has deformed roughness with marks that look like a mold bar has been sheared off. A file is required to remove anyโ€ฆ

Pros
  • Female holes on both ends to connect two male fittings
Cons
  • Not bad, but...