Header banner
Revain logoHome Page
stlink v3 modular circuit debugger programmer logo

STLINK V3 Modular Circuit Debugger Programmer Review

1

·

Poor

Revainrating 2 out of 5  
Rating 
2.0
🧰 Computer Internal Components, 💻 Computer Components

View on AmazonView on ЯM

Media

(1)
img 1 attached to STLINK V3 Modular Circuit Debugger Programmer

Description of STLINK V3 Modular Circuit Debugger Programmer

JTAG / serial wire debugging (SWD) specific features: 3 V to 3.6 V application voltage support and 5 V tolerant inputs, Flat cables STDC14 to MIPI10 / STDC14 / MIPI20 (connectors with 1.27 mm pitch), JTAG communication support, SWD and serial wire viewer (SWV) communication support. Stand-alone probe with modular extensions. SWIM specific features (only available with adapter board MB1440): 1.65 V to 5.5 V application voltage support, SWIM header (2.54 mm pitch), SWIM low-speed and high-speed modes support. Virtual COM port (VCP) specific features: 3 V to 3.6 V application voltage support on the UART interface and 5 V tolerant inputs, VCP frequency up to 15 MHz, Available on STDC14 debug connector (not available on MIPI10). tand-alone probe with modular extensions Self-powered through a USB connector (Micro-B) - USB 2.0 high-speed compatible interface.

Reviews

Global ratings 1
  • 5
    0
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 2 out of 5

Short circuit in the cable, no overcurrent protection

This would have gotten a pretty high rating were it not for a short in the connection cable I used that comes with the kit. To use this device I have to hold it in a certain position and not dodge it or it will drop the debugger, my programmable device and the USB port that runs everything on my computer. For everything to work again I have to restart the computer, which is a terrible ordeal.

Pros
  • All right!
Cons
  • Expensive