🔧 Sunex 884501 9/16-Inch Spark Plug Socket - 3/8-Inch Drive Review

Rosette not deep enough. The socket I bought in Pre-Auto is a bit deeper and cheaper. waste of money. Do not buy to replace spark plugs! It's too short.

Worked on my 05ft F-150 (5.4) spark plugs. I would recommend putting a very small drop of lube on the rubber insert to keep it from pulling out from the connector. Worked like a charm for me after that. A good product!

I needed this to remove the spark plugs on my wife's Mazda CX5. Easily removed the plugs. It was not easy to remove the socket from the newly installed plug. I switched to standard 9/16 for the installation.

This works really well but the plastic rubber inside that holds the spark plug gets stuck in the spark plug and I had to take the spark plug out again just upside down because it would be very difficult to get out if the spark plugs are very deep.

Base not deep enough. The socket I bought in Pre-Auto is a bit deeper and cheaper. waste of money. Do not buy to replace spark plugs! It's too short.

Worked on my 05 foot F-150 (5.4) spark plugs. I would recommend putting a very small drop of lube on the rubber insert to keep it from pulling out from the connector. Worked like a charm for me after that. A good product!

I needed this to remove spark plugs from my wife's Mazda CX5. Easily removed the plugs. It was not easy to remove the socket from the newly installed plug. I switched to standard 9/16 for the installation.

It works very well, but the plastic rubber inside that holds the spark plug gets stuck in the spark plug, and i did it to take the spark plug back out, be careful because when the spark plugs are very deep it can be very difficult to extract it.