Synergy Manufacturing 8003 10 Suspension Stabilizer Review

The bracket is durable. The product arrived on time. Wrong size of my mistake, let's see how they deal with customer service. Overall a great product.

After installation I checked that everything was ok and found that one of the screws was broken. Especially for so much money. Not impressed, I hope the seller sends a new one

Steering stabilizer movement fixing pin not included. Oddly, the Synergy tie rod relocation kit comes with a mounting pin while the JL standard tie rod kit does not.

I used this on my 2006 Dodge Ram which has an updated 08.5 T-steerer and later 4th generation Dodge pistons. It fits perfectly. The 1/2 bolt is the same size as the factory bolt so everything ran smoothly. I switched to this yoke because it doesn't protrude that far out of the tie rod, my "factory" yoke hit the mag-hytec front diff cover. This keeps the steering damper clear of the diff cover and it looks like a half price car.

I like it but think I'll have to tighten it a bit tomorrow. The stabilizer bar goes at an angle, but this screw goes straight into the fork, to install it I had to loosen it a little, align the screw, turn it in different directions and then gradually tighten everything. Make sure you get the right size for your tie rod, I have Synergy 1 and 3/8" tie rods, they also make a 1 and 5/8" clamp.