🛁 KES Bathroom Shelf, 19.6-Inch Tempered Glass Shelf (8mm Thick) Wall Mount, Brushed Nickel Finish - BGS3201-2 Review

I really like the look of this shelf and I think it's well made. Note, however, that the shelf brackets will slide out about 3 inches and will require some sliding from the bottom. In order for this to happen and end up screwing tight, you need to adjust it a few inches. especially what can hit him. I installed it just above the bathroom sink with a small splashback that mounts to the wall like a regular splashback and the clearance required at the top meant it was mounted much higher than I…

Great tempered glass shelves at a great price. We wanted shelves in the shower for shampoo and other essentials. After looking at the crowds, we settled on these semicircular glass shelves from KES Home. Good thickness (8mm), tempered glass and polished beveled edges but best of all strong, well made and firmly attached brackets to hold the shelf. We are not afraid that the shelf could move on impact. All in all a great attractive product at a great price! We recommend this product in the…

I love these shelves. Met all expectations with a shelf that I was able to install. Unfortunately, the person I hired to install the shelves lost the second set of gear. Left a question, the seller answered. However, the recommendation to get a replacement hardware kit under "Your Account" -> "Your Orders" -> "Order Problem" is not available for most of the items I have ordered, otherwise I would have already contacted them through this tool . This option is only available for some items.

I bought this for the polished nickel finish and the sleek look. I bought it in November 2019 when renovating a bathroom. I only installed it 4/2020 due to a delay with my bathroom cabinets. It arrived with no instructions but I was able to figure it out myself and not only is the workmanship of the two wall brackets defective, the spot where you screwed in the bottom screws wasn't fully machined(?) that cuts holes. and both pieces had sharp splinters of metal. I couldn't return it due to the…

The product works as intended but without instructions. So I'll leave the instructions here. Placement instructions: 1. Loosen the screw at the bottom of both metal pieces to open the gap between the rubber pieces holding the glass in place.2. Insert the glass into the hole and tighten.3. Move the piece of metal around until you are happy with its placement.4. Measure the distance from the center of one piece of metal horizontally to the center of another piece of metal. Should be about 8-10…