🚽 Thetford 70400 RV Sanicon Systems Nozzle with Cap - Enhance Your Waste Management Efforts! Review

If your van has a grinder this attachment is perfect for attaching to your hose. It fits any siphon, is easy to use and you avoid the mess of draining waste, especially in the storage compartment where the grinder is located.

I purchased this item to replace the item that came with my unit. It has arrived in good condition. I hope everyone who buys this item at this price understands that you are NOT getting everything that is shown in the picture! There is only a black plastic nozzle in the upper right corner.

This was a replacement hose for my Sanicon system in my RV. The hose is always connected and ready to use. The 21ft hose takes up much less storage space than my old 4" hose. I would recommend a Sanicon system with a 21ft hose that has room to mount this system.

This nozzle is well designed and works well unless you are trying to bleed your tank without removing the screw on the cap like I did the first time. The stitching under the handle ripped and leaked in one spot, so I had to make another one, which is the reason I ordered it. The product itself isn't bad, although it's made a little lightly.

Just what I need to keep my hose down the camping drain even though my chopper has a smaller hose and can't seal. Instead of opening the lid every time I need to drain, I just stick it in the drain hole and attach the chopper hose. I've been looking for a suitable part for a long time to solve this problem and here it is.

The concept is great! The performance did not meet our requirements. The SaniCon hose is loose enough to slide onto the fitting so a clamp is required. Also, before screwing the nozzle into the duct fitting, the clamp must be removed and the hose removed since there is no swivel joint where the inlet tube enters the duct fitting section. Also, the device for inserting and removing the sewer hole in our bus has to be removed because the opening and service compartment devices do not allow it to…