Header banner
Revain logoHome Page
⚙️ industrial electrical torque turbo geared motor - 100rpm logo

⚙️ Industrial Electrical Torque Turbo Geared Motor - 100RPM Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.7
🔌 Electrical Controls & Indicators, 💡 Industrial Electrical

View on AmazonView on ЯM

Media

(4)
img 1 attached to ⚙️ Industrial Electrical Torque Turbo Geared Motor - 100RPM
img 2 attached to ⚙️ Industrial Electrical Torque Turbo Geared Motor - 100RPM
img 3 attached to ⚙️ Industrial Electrical Torque Turbo Geared Motor - 100RPM
img 4 attached to ⚙️ Industrial Electrical Torque Turbo Geared Motor - 100RPM

Description of ⚙️ Industrial Electrical Torque Turbo Geared Motor - 100RPM

☀No self‐locking, working well. ☀The gearbox output shaft direction of the motor shaft is arranged vertically. ☀Suitable for: Widely used in windows, a door opener, miniature winch and other occasions​. ☀No-load speed choice : 5rpm / 6rpm / 20rpm / 40rpm / 62rpm. ☀The entire body of the motor output shaft relative to the general direction of gear motor short, widely adapted to some of the installation sizes of this aspect is required.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

Burned out in a few minutes

I've had good luck with this type of motor before, but this one seems to have burned out after a few minutes with a light load. I measured the resistance of the wires, which confirmed the lack of continuity.

Pros
  • ☀No self-locking, works well
Cons
  • There are other interesting options.

Revainrating 5 out of 5

Motor runs great, fairly quiet

This motor shaft has been adapted to a 40" threaded rod to wind on some 4.5" PVC pipe (on bearings) for painting and epoxy application . The epoxy takes over 8 hours to cure and I ran it at about 50% speed with the speed control. It's been 8 hours, no problem. The sound is quiet, the engine/transmission a little warm, but far from operating temperature. About body temperature. When it was new it got louder a few times for a few seconds. But after hours of work I haven't heard from him since.

Pros
  • ☀Motor Shaft Transmission output shaft is vertical
Cons
  • Very Expensive

Revainrating 5 out of 5

The higher the speed, the less power.

I love these small motors! I've been using one of these (20rpm) for my fishing boat steering gear for the past two years and it works like new! I was initially skeptical that it wasn't strong enough, but it gets the job done with no difficulty. Bought this as a replacement. The first thing I did when I got it was open it up and look for little metal plugs that might have gotten into the gears. I've seen reviews where this has happened. It was really clean but there wasn't enough lube in it so I

Pros
  • ☀The entire body of the motor output shaft relative to the general direction of the gear motor is short, widely adjusted to some installation dimensions of this aspect is required
Cons
  • No power