🐷 Backup Molded Pigtail Harness for Trailers Review

You cannot use wires of the same color for your current installation, you need to find out which wire is ground and signal.

Entire box not properly connected. Cannot be used with taillights or other lights. I bought a whole box and we tested them all after the first one didn't work and ended up being a whole box.

This is rubbish. I just spent 30 minutes blowing fuses and swapping wires before realizing the wires weren't color coded correctly for a standard plug. Some pigtails have a black wire, others have brake lights! ABSOLUTE GARBAGE

Not only do the colors match as always, it's an asshole and I had to rewire my trailer twice thinking I had a short but in fact those stupid plugs are misconnected black wire is grounded to the theses, not the white like a mainsail or optronic braid, the fit and finish was not good quality, kept falling out, save your time and trouble, buy a quality mainsail braid

I bought them because my spark plugs had melted. I hooked everything up and the damn running lights flashed when I turned on the right turn signal. I traced all my cables and reconnected the plug but the problem was still there. The left signal didn't work either. I connected another light and everything worked. Well there is a short in both plugs I used because once I cut them off everything else works fine. They gave me a lot of headaches and I will be sending them all back. Don't buy them as

Received these cables today. The plastic connector itself fits well. However, the cables are in the wrong order. With the pins facing me and the wires hanging onto the floor from left to right, the order of the wires is red, white, black. The wires on my original equipment are black, red, white in order. My original wire connector is 16 gauge wire. This is 18 gauge wire, slightly smaller. Interestingly, the photos show the wires in both versions. To be honest this may not be a deal breaker for…