🔧 UBIZ0260 RC3860 Replacement Manufactured in Connecticut: A Robust Solution for Top Performance Review

I have a house that was built in the early 70's and I have a Zinsco panel. It is functional and has no defective style breakers. I wanted to add an extra panel for my wood store in the basement. After searching the internet I found it available because I needed a 60A bipolar switch to power the subpanel. I just installed the switch and found that one of the 120v legs of the switch is not working. Worst of all, now I have to go back and penalize another breaker. Don't waste your hard earned…

Bought this switch to replace a melted 60Amp circuit in my GTE Sylvania load center. The switch clicked as expected and seems to work fine. However, when I tried to put the faceplate back onto the switch box, it wouldn't go into the hole. I figured the plastic breaker would be easier to cut than the metal plate, so I did (it was about 3-5mm off). This was made in China. I'd buy more of these if I needed them, but until then I'll probably upgrade my dash to something newer (and less fire prone)…

I ordered this switch in August 2015 for my daughter's house. We previously attempted to order a hammer from another Revain source and were told the order would take up to 24 days and there was nothing Revain could do until the full time was up. We waited a full 24 days and discovered the item was never shipped. Very disappointing. I then reordered the switch from Connecticut Electric and shipped it to my daughter's home in Florida. I told her if she couldn't find an electrician to install it I