🌬️ Universal Car Windshield Washer Pump System 12V with Jet Button Switch, Reservoir Tank Bottle Kit 160186 - All-inclusive Universal Windshield Washer Kit Review

Almost identical to a 25 year old rotten RV wash tub. Easy installation. I didn't have to use any attachments for my application. Hold about half a gallon.

You know it was easy to install an old factory mobile that was 25 years old. Popped straight into his works, goes great with all fittings

Easy replacement of a failed factory pump and washer reservoir. The polarity of the two cables to the pump didn't matter. Easy installation, just two screws for the bracket and the tank is placed on top. The remaining parts from the kit did not have to be used.

Nice set. Works well. But the reservoir is too small. It's hard to tell from the picture. If the tank was twice the size I would give it 4 or 5 stars. You should put it next to a can of coke to balance it. I used it on an old RV where the original plastic block fell apart.

I installed this in my RV in 2019. Due to the pandemic last year I didn't use it at all. Total usage was probably four or five times. Once when I received and tested it, and maybe two or three times in a year and a half to two years. I used it this year and it didn't work, the pump got stuck, it doesn't work, not worth buying junk.

Plastic container molded to a bracket that attaches to the engine compartment. You lower the tank into the bracket. However, when you first fill the tank and then drive over a bump, the weight of the liquid deforms the plastic enough that it slips off the mount. . The first. Time. And as others have said, the pump isn't impressive either.

I installed this on my 2017 RZR 900 Trail. Installation is easy. It works as expected. I would prefer the pump connector to be waterproof and this will change in the future. I also wish the spray nozzles were mistier than jet, but they do their job well. You can adjust the spray angle of each nozzle with a small tool. There are no instructions, but installation is easy.

The holder is not made of metal, but replaced by plastic. It's maybe a small 2 liter container. Electric cable Chinese! The wire is very thin and prone to future problems. When you fill the container with water! Slips out of the holder. And it falls! There can be a problem if it hits a fan blade or a moving mechanical pulley etc! The tie rod attached the container to the car frame!