🔧 Enhanced Snap Installation Fastening Replacing: Upgraded Version Review

I crushed the 1st click but it still works. Once I realized I needed to focus more on the pin's position, the latches were perfect. It does what it's supposed to do for 1/3 the price of a 'real' one, so I never need an upgrade. The interchangeable lower jaw "anvil" comes out too easily - no problem in the store, but not so good in the dock. It would be better if it was a little more secure, so 98.5% is perfect.

I didn't receive the "updated" version at first, although I ordered it. The inserts fall out with each crimp. They're held in place by a crappy o-ring that doesn't even tighten them. The vise grips are the cheapest quality and in fact the grips make you think it is a well known brand. For cheap snaps, it works well. It sucks to put up with a constantly falling stamp. If you take a lot of pictures, buy something else. Constantly chasing the drop-down dice sucks. If you use this for stainless…

I recently got a new cover for my pontoon boat and when the marina installed the latches they did a terrible job. About 15 pictures fell apart in two weeks. I bought this tool to fix the fasteners myself. The kit included a tool and a set of latches (internal and male). The instructions could have been a bit better, but it wasn't difficult to understand how to use it. Made a trial notch on a piece of leftover canvas to set the tool for proper clamping pressure. I didn't have anything to punch…