Upright vacuum cleaner YTE Vacuum Cleaner S7 Global -EU Review

The vacuum cleaner is powered by a built-in lithium battery. Before first use, charge the battery for at least 3.5 hours. Notes: The vacuum cleaner cannot work while charging. The power indicators blink while charging and remain white when fully charged. The power indicators flash when the battery is low. The vacuum cannot be charged if the ambient temperature is lower than 10°C/50°F or higher than 45°C/113°F. CleaningBefore use, make sure the vacuum cleaner is fully charged and the dust container and filters are clean, dry and secured in place. Maintenance For optimal performance, follow the instructions below to clean and maintain your vacuum cleaner regularly. The cleaning/replacement frequency will depend on your vacuum cleaner usage habits. Recommended cleaning/replacement frequencyClean the dust container and filtersAttention!Turn off the vacuum cleaner before cleaning. If the dust box is full of dust, the vacuum cleaner may stop to prevent overheating. Empty the dust bin before it fills up to the MAX mark. Disassemble the metal tube. Press the dust removal button to empty the dust box. Press and hold the dust bin release button and turn the dust bin clockwise to release it. Turn the metal filter clockwise to release it. Rotate the HEPA filter clockwise to release it. Remove sponge filter. Shake off debris by tapping the filters on the trash bin. Rinse the dust container and filters. Dry the dust bin and filters completely before reassembling. Note: Do not use a brush, hot water or any detergent to clean the filters. Attention!• Keep away from direct sunlight. • All parts must be completely dry before reassembly. Install the sponge filter onto the HEPA filter and turn the HEPA filter counterclockwise to install it into the metal filter. Rotate the metal filter counterclockwise to install it into the main unit. Make sure that the slots on the dust box match the fasteners on the main unit, and then insert the dust box upwards into the main unit. Turn the dust bin counterclockwise until it clicks into place. Clean the rotating brush Turn off the vacuum cleaner, press the floor brush release button to remove the floor brush from the metal tube. Press the rotary brush release button to release the rotary brush locking bar. Remove the rotating brush locking bar and lift the rotating brush to remove it. Clean the rotating brush with scissors or other tools, rinse and then air dry the rotating brush. Replace the rotating brush by first inserting the fixed protruding end and then clicking into place. Press the locking bar of the rotating brush until it clicks into place.