Header banner
Revain logoHome Page
uxcell coupling l22xd14 coupler connector logo

Uxcell Coupling L22XD14 Coupler Connector Review



Very good

Revainrating 4 out of 5  
🔌 Couplings, Collars & Universal Joiners, 🔩 Power Transmission Products

View on AmazonView on ЯM


img 1 attached to Uxcell Coupling L22XD14 Coupler Connector
img 2 attached to Uxcell Coupling L22XD14 Coupler Connector
img 3 attached to Uxcell Coupling L22XD14 Coupler Connector

Description of Uxcell Coupling L22XD14 Coupler Connector

Connection Diameter: 6mm to 6mm, Total Length: 22mm /0.87 inch, Outside Diameter : 14mm/ 0.55 inch. Widely used in blowers,3D printer,DIY robots,CNC machine,stepper motors,etc. Similar to rigid clamp couplings, shaft couplers are used to hold bearings and sprockets tightly on the shaft, and are used in motor and gearbox assemblies. Top tight type rigid coupling with 2/4 screws to hold the shaft tightly; high torque with rigidity, low inertia and excellent sensitivity. NOTE: The rigid type basically does not allow eccentricity, and it must be fully adjusted during use. Single piece set screw clamp design makes it easy to set up the items on the shaft and control the holding capacity of the coupling.


Global ratings 3
  • 5
  • 4
  • 3
  • 2
  • 1

Type of review

Revainrating 5 out of 5

Durable Coupling Connector for Industrial Use

This coupling connector is an excellent addition to any industrial setup. It's durable, sturdy and can handle heavy-duty jobs with ease. The quality of the product is impressive, and it's long-lasting, making it a great investment for any business. However, it may require an experienced technician to install, which could add additional costs. Overall, a fantastic coupling connector for any industrial and scientific needs.

  • Easy to install and use
  • May not fit all types of pipes or connectors

Revainrating 1 out of 5

Product packaging is dumb

Couplers and set screws are in a bag. One of my adjusting screws managed to get back in. For example from the INSIDE of the clutch, with the end of the Allen key INSIDE. Can't get the screw out, can't insert the shank.

  • Nice packaging
  • I don't remember

Revainrating 5 out of 5

Excellent quality

I am building a cased annealer and needed to lengthen the shaft of one of the drive motors. I used this as a clutch and it worked great! Tolerances were tight enough that at the low speeds they used, the two shafts lined up perfectly with no wobble or misalignment. The adjusting screws are large enough to barely cut into the waves. I highly recommend sanding down a small, flat surface for mounting the set screws. I am very happy with the purchase. You did it!

  • Best in its niche
  • I will add later