Header banner
Revain logoHome Page
uxcell groove bearings 16inch double logo

Uxcell Groove Bearings 16Inch Double Review

3

·

Poor

Revainrating 2.5 out of 5  
Rating 
2.4
🔩 Bearings, 🔩 Power Transmission Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to Uxcell Groove Bearings 16Inch Double
img 2 attached to Uxcell Groove Bearings 16Inch Double
img 3 attached to Uxcell Groove Bearings 16Inch Double
img 4 attached to Uxcell Groove Bearings 16Inch Double

Description of Uxcell Groove Bearings 16Inch Double

R8RS (I.D.=1/2inch, O.D.=1-1/8inch, Thickness=5/16inch). R8-2RS bearings are sealed on BOTH SIDES to keep lubricant in. Made from Bearing Steel, durability and resistance to under heavy loads. ABEC Tolerance 1 (P0), Z2 Noise Level for most general use. Static load rating of 511 newtons and dynamic load rating of 1149 newtons.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    2

Type of review

Revainrating 1 out of 5

Horrible Quality Bearings - Avoid!

Based on our own experience, these bearings were a complete waste of money. While the price was attractive, the quality was extremely poor.The bearings were noisy and had a SHORT lifespan. We ended up having to replace them much sooner than expected..

Pros
  • Affordable
Cons
  • Poor quality, short lifespan.

Revainrating 5 out of 5

Reliable groove bearings for your power transmission needs

Based on our own experience this set of double groove bearings from a certain brand proved to be a reliable choice for our power transmission needs .The bearings are sturdy and well-made, ensuring smooth and efficient performance as expected. The installation process was also quite easy, and we appreciate the precision of the bearings' dimensions. Overall, we highly recommend this product to anyone looking for a dependable solution for their bearing needs..

Pros
  • Reliable, well-made, smooth performance, easy installation
Cons
  • None observed

Revainrating 1 out of 5

Good stock but wrong size.

The quality seems good enough but it's not the right size. I ordered 1/2 Int. x 1 1/8 outside. A trial mount with 1/2" shaft didn't fit. The inner size of the mics are 0.48 and 12mm respectively, the outer size is 29mm, not 1.125. Oddly enough, I also ordered 12mm x 29mm stock for another project. They showed it was the same bearing Hmmmm I have a lathe so I can get these millimeter bearings to work but it adds to the assembly time Someone without a lathe would have to make some serious sworn…

Pros
  • Absolute legend
Cons
  • High price