Adjustable Sewer Hose Carrier - Valterra Products Inc A04-3460BK Review

Mounted on frame rails. I drilled 1/8" holes and used the supplied self tapping screws. No problem. You can get tubing from either side.

Very well finished. plugs at both ends. Glides and adjusts to a specific extended length or whatever you need. Do not use the set screws provided. I didn't want to mount it on the roof of my tiny T@B trailer. attached to rear luggage rack instead.

Pretty thin stuff. The screw on the cover has been tightened, and it's no more a push than a screw. The overall material construction is lightweight - I'd probably recommend a different option for those who need something more durable.

I bought this unit to replace the original storage box that came with my van. Please note that the Revain image shown is incorrect. Valterra replaced the original flimsy hinged caps with screw caps. They seem much stronger.

In my case I have two caravan frame frames. If I were to attach it to the frame, I would have to crawl under the trailer to get the drain hose. Installed under the bumper homemade brackets. One note: this will accommodate your bumper-like hose (which you don't want your bumper to rust), but it's not big enough to take your elbow out, which could end up in a fuel tank hole in the floor. You must detach the header from the tail and stow it separately. I put mine in a large ziplock bag.

With limited outside storage for a 27ft RV I wanted a way to store my smelly skinny car. I wasn't very keen on rusting the inside of my steel bumper, so this seemed like a good option to keep most of the outer storage case. I got some heavy duty extra long zip ties from my local Big Box hardware store and in about 5 minutes the tube was firmly attached. Four zippers appear to secure the tube firmly. I ordered another for the other side of the bumper to accommodate another section of hose (the…

I was a bit hesitant at first because I wasn't sure if my Rhinoflex hose tails would fit, but they do (you have to pin them first). They are amazing and I bought two. Glad because I don't want to store sewer hose nozzles anywhere else. The adjustable length is a real benefit during installation. I used metal screws, not the ones provided. I have two 10ft Rhinoflex hoses and keep one hose in each holder, extended to 48" and 42" respectively. I keep my elbow pads in a longer holder.