Valterra TR38 Wye Rotating Valve - 3-Inch Hub x 1.5-Inch Hub x 3-Inch Bayonet Cap, Black Review

I was able to easily remove the valves and gaskets and replace with old ones that broke. If I had to replace the entire unit it would require some cutting and PVC glue but it would still be relatively easy. Good product.

Excellent seals and smooth valve operation. Thick ABS plastic that will likely last for years. 3 stars for "easy to install" because you have to cut and re-glue the ABS pipes. The ability to change the position of the valves at any angle is convenient. .

A tank valve was leaking on my 30 year old caravan. Couldn't believe I could get a complete block with both check valves just like the original. I simply unscrewed the glue on the pieces and screwed directly to the old ones. Absolutely no problem. Highly recommended

After busting my black and gray valves in an arroyo in the desert I was glad to find this replacement! It fitted perfectly, although I had to mount one of the broken joints on the gray tank! Item arrived early and was professionally packaged! Works great!

It was really easy to install once you took the old one off. You have to cut it off. Then the new pipe is adjusted to the new length by trial and error. I had to trim the channel side about an inch to allow the gray side to fit snugly. Use lots of glue to keep it from leaking.

This is a durable and well thought out product. However, it is a single component and inextricably linked. If you're not sure if your black and gray drains connect at a certain angle, I strongly encourage you to find another product. I ended up throwing this product away because I was so disappointed that it wasn't worth returning.

Great delivery, after a few modifications my trailer worked great. I used to have the Bristol brand which is harder to find. Techs said they are compatible with each other, which isn't true without some installation modifications. It took a little longer to install but now there is a better brand to get replacement parts.

The original design used cable operated valves which both stuck open when we bought our 2001 RVision Condor in 2012. It took two men five hours to replace the valves and four years later the black water valve. put open again. I completely redesigned the drain pipe from the tanks to the outside and placed this assembly where it is much easier to work with and the valves can be swapped out in ten minutes if needed.

It appears to be a well made product. I bought this to replace the existing Valterra drain on my 1986 16ft camper trailer. I don't know if the valves I replaced were original or not, but they looked pretty much the same as this kit. So I bought them hoping it would be a direct exchange. I didn't want to cut the ABS pipe. So my plan was to just unscrew the valves on the flanges and screw the new ones onto the existing flanges. I cut out Luckily I had enough room to cut off the existing flange…