💪 Enhanced Performance and Durability: VCE Shielded Modular Stranded Ethernet Industrial Electrical Solution Review

Got them shielded for 6a. It fits on shielded 6a with no problem. The problem I had was that arranging the ladder in the right order and cutting it to the right length was very difficult as there is no passage. The small plastic comb that separates the conductors does not have separate holes for each conductor. So if you are not careful when inserting the conductors before crimping, the conductors may change position. So it's a high quality connector, but very tedious to get it right. I buy the

Very disappointed with this purchase. The instructions are barely legible. The mini boot poles are about 3/8 and don't slide over the wires easily. After trying to build 12 patch panel jumpers I switched to another manufacturer. Guide bars give the impression that the wires are lined up in the correct order for loading; However, check the final connections to determine that the load bar does not fit properly into the RJ45 jack. Therefore, skip aligning the selected wires when they are finally…

The cable run has poor connections during installation and testing. I installed a different connector on one end and it showed that more pins were connected. We work on the other end of the cable - install a few more connectors and try to make a good connection. The problem is that the pins bend when they hit the wire insulation and go to the side rather than going through it to make contact with the wire. At various attempts, some mated and one or two contacts left unmated, while other…