Vibrant Cup Holders By Brybelly Review

We have purchased significantly more expensive cup holders, but they never seem to fit the actual cups we use so we returned them. My husband is building a console for a custom truck build, and these actually look great in his design, and they will fit not only our insulated cups, but also a large size McDonald's cup very nicely, and they are deep enough that the cups are not likely to tip over when turning a corner.

This is definitely not what I was expecting.I had ordered 2 other ones that were either too wide, or too narrow. This one seemed like it would be perfect, and the size it almost perfect.It fits a 20oz bottle of Coca-Cola perfectly (standard size to purchase at a gas station when I'm traveling).I also like the fact that it is deeper than the other two that I purchased, although it may be too deep (I wish I could find a happy medium).The main issue is that it is thin and maleable aluminum. I knew

Perfect fit! I needed cup holders for my toyota mini offroad truck. These worked perfect! I did uses 3.5" hole saw that will work but if you can find the size they recommend I'd use that.

The quality of these are not as expected. They are very thin- one was bent on arrival. Will be returning today. Thanks for attention!

The red ones are pink, not red, and the aluminum is fairly lightweight. Not great, but not awful. They run true to size, that is, they match most car cup holders for size.

Very thin metal and bends very easy. You can easily bend it with your hand. If the metal was twice the thickness it would be perfect.

This gets a 3 for making it in this size. Very hard to find. I will use them but they are so light I would guess they have no more aluminum in them than 4 or 5 beer cans. On a boat there should be a drain hole to empty into the bilge but I was just happy to find anything in this diameter

Horrible, horrible, horrible. Made of a material not yet discovered by man. this flimsy material dents when a fly lands on it. God forbid you wash it. actually melts in water. Stay away from this unless you are searching for a cool bar trick.

Pros.Come in multi colors.Approximately 3 inches deep and 3 1/4 wideConsMetal used is soft, Easily dented.Cups with ears need not apply.The rim is of this cup holder is narrow.

large cup holder but this is 85mm outside diameter and standard american hole cutter wil not work. buy the 85mm cutter That's my feedback.

Installed this in my kayak as a drink holder. love this product! Easy to remove for cleaning!. Cut out a small hole in the top and it's a great fit. Perfect!

I guess I should have known? Very cheap replacement for my stainless steel cups. So I have two that weigh half as much and don't match my other cups. Just be aware of what you are replacing and ok that they might not match visually or quality.

These are barely thicker than a beercan! they bend and dent super easily, and don't have a finish at all on them, so they have lots of tooling and stretch marks visible.