VonHaus Wall Mounted Plastic Pegboard and Shelf Tool Organizer - DIY Garage Storage System with Rack and 50 Assorted Hook Accessories - Efficient Tool, Parts, and Craft Organization Review

Recommended not to buy, good thing I got it because someone doesn't use it often, this thing is awful, I shouldn't be trusted but personally I wouldn't get it professional work or unprofessional work for that matter.

The overall quality of this product is poor at best. Very cheaply made. The pins don't snap which keeps them falling out when you use the product on this pin. In the picture it looks much better than in real. Unfortunately I would not recommend.

Not very good quality. Remember it's plastic, I knew that when I bought it. However, the mounting hooks come out easily. So if you grab something quickly, they'll jump out and fall to the ground. Looks made for children's instruments. Hooks and hangers are also not very intuitive for tool types. Maybe cheaper in Europe where things are of lower quality.

In our opinion: This perforated plastic panel was very thin, so we felt it necessary to reinforce it by attaching the back panel to the wall and fastening it with bolts. Some of the pins were difficult to set due to the poor quality of the "board". We didn't even use the orange "shelf tool organizer" because we found all the holes were a mess (try to figure out which tools go with which holes). see attached photos

The material is pretty cheap thin plastic. The orange clips/hooks that are meant to hold the tools are either too small or too big to hold regular sized tools. They also cannot support the weight of heavier tools, causing them to break. The orange baskets have different sized holes for storing tools, and again the same problem. The holes are either too big or too small for regular sized tools and don't look ridiculous.

It would be easy to install if the anchors and mounting screws were included. But as soon as I realized that the hooks were useless, they are junk and a waste of my good money, I would have sent them back if they weren't now screwed to my wall. Don't waste your money. I would like a regular peg board with regular hooks that stay in place and really hold the tools. piss off!

I bought these after setting up my husband's 'work shed' in the spare room so all his repair supplies weren't scattered around the house. I love these little things! So I had to hang them up because Mr. Fixit never bothered to hang them up, ff (sigh). Pretty easy, I just used a couple of wall anchors to make sure it was secure. Those little orange hooks actually carry a lot of weight, like a big hammer, screwdriver, etc. I think other people have mentioned that it's a good idea to glue them in…