🚗 Walker Exhaust System Hanger Insulator - 35296 Review

Excellent insulators. Used them on my trucks 4 inch pipes, factory dated and rattling. Several holes worked perfectly.

I needed 2 of these holes to install the exhaust pipe and 4 holes make the installation easier, just use the 2 that suit you best.

On the top left of the picture. It's a (adjustable?) rubber muffler bracket. Actual dimensions: 145mm x 39mm x 20mm. The hanging holes have an inner diameter of 12mm and are located every 38mm center to center.

I had to use lube to put (import?) it onto the shaft of my Astro-Van. Turns out I needed 3 but only got 2. Also, mine wasn't made in Canada, it was made in another country.

It suits me. It's more durable than traditional hangers so doesn't look like it's going to stretch as much. Allowed me to hang the exhaust exactly where I wanted it. 2001 Silverado 2500 HDEdit Adding the second allowed me to fully fix the slightly curved exhaust. Having multiple hole options is great.

I lost about an inch in length installing double pane on my 2003 Silverado, it pulled the stock hangers off track and the exhaust too high raised . It was the perfect solution to getting the exhaust back to where it should be. I used 2 of them in total. 1 at the very back, 1 in the middle and furthest to the front left in stock. Good product.

This is a rubber stud with 4 holes at the same distance from the center line as the standard Toyota exhaust hanger isolator. I think if I needed a slight adjustment it would be one hole too short and two holes too wide. I ended up cutting it in half with a razor knife and turning it into two of the cheapest heavy rubber hangers. So far so good silencer sticks to my tundra.