💡 2-Pack ATX Power On Off Reset Switch Cable with Dual LED Lights (Red and Green) - 27-inch ATX Case Front Bezel Wire Review

Love that there are 2 in the pack, wish I could only buy 1 but it's so cheap it doesn't matter. Very simple, it does everything you want and expect perfectly 😂 I just wish there was a little indicator of which button is which. Otherwise it's almost perfect.

Bought to replace worn out power and reset buttons on my Antec Three Hundred case, the second one works fine now in the Housing. I'm glad there were two because I installed the first one incorrectly and the wire came loose from the solder joint. But it's an installation error, not the product that caused the error. The wires are pretty thin, but that's to be expected. I am satisfied with the purchase, especially since there is a second one in the kit.

I needed something to make powering up the systems on the test bench easier. Tired of the method"screwdrivers to jumpers". These 2 packs were pretty cheap. Each port is marked with positive and negative markings. I would definitely recommend any PC builder/techie to have it in their toolbox.

Came an enclosure without HDD LED and that's what I needed. Each individual wire can be easily removed from the main wire assembly if you only need one wire like I did. The wire colors in the description and the wire description in this ad are correct. I will buy again when needed and you will receive (2) sets, plus!

Works as advertised! Cheap but great. You can easily separate the wires to separate the LEDs from the buttons if you need to keep them further apart.

If you need front panel buttons and indicators then this kit is for you. I needed an LED for my system's hard drive activity indicator, it worked like a charm.

I have an ATX motherboard that doesn't have a built in start/reset button so this was a good alternative and cheap too. The length of the cables is just perfect and it's nice that they are colour-coded.