Enhance Performance with WaveEater Power Valve Clip and 🚀 Couplers Kit - Boost Your 1200cc & 1300cc Yamaha WaveRunners Review

Good. They warn you that the clutches are tight. It is true. Makes it tricky because you have to hold the spring and washer while you're doing it

Got these for our two XLT1200cc Waverunners. Installation is very easy for both clamps and couplers. Just don't drop anything in your suitcase!

Fits as promised. However, the instructions for the plugs were wrong. Went to their website where the instructions were correct. Just be careful when installing the clamps so the cables don't come out of the wheel.

Bought for my 2005 XLT1200. The power valve clips fit well. The clutches would not engage no matter what I did. It looks like the pin that fits into the grooves on the power valve shaft is too large in diameter. I can't use them and already have the clips installed. I hope Wave Eater either sends me a replacement or gives me some of my money back.

Clamps fit great, this is the original design tried and tested, not the cheap clamps which should be provided to prevent a socket head screw from loosening. The clutches are well thought out, but on my '02 GP1200R they were very tight on the power valve shaft. Now there is no play in the power valve system. I encourage everyone to check their wiring system after installation per the factory manual. Checking takes no more than 10 minutes when using the Yamaha 4mm hole provided in the pulley. I…