WFLNHB Carburetor Rebuild Evinrude Outboard Motorcycle & Powersports Review

This product sucks, as soon as you put gas in the carburetor, the bowl gasket swells to twice its size. I would not recommend this carburetor

Worst gasket set. At first they were weak the first time they were eaten. I had to disassemble the carburetor again and change the gaskets after a break-in.

Absolute nonsense. I only drive fuel without ethanol. In less than a week, the pads were swollen and discolored. Fittings are threaded incorrectly. Buy OEM.

Do not recommend buying I installed them and couldn't start my boat so I disassembled the carburetors to find them. was only in carbs for a few hours

All parts were included and shipped quickly, but the float valve seat threads were incorrectly pitched and the float valve bore was a smaller bore size. And yes, I checked the model numbers before ordering. All pads fit true to size. The floats are hollow compared to the originals which were solid. Basically, you can't use the new float valve seats due to thread mismatches, and a smaller bore can result in a slower carburetor chamber fill rate. Although there are no problems with the return.

The main seal crumbled and the fragments fell into the jets and needle valve seat. It worked the very first time I took it out and then it started starving the engine for fuel. So I had to disassemble a freshly repaired carburetor that still looks sparkling clean save for the big black gasket pieces stuck inside. I have repaired these carburetors a half dozen times over the years but this is the first time I have bought a cheap repair kit from Amazon rather than a kit from a boat specialist…