Whedon Products SU8C Double Sprayer Review

I've had this aerator for about 9 months now. It has much better flow and pressure than what I got at my local home center. The double twist is great, it reaches most of my 42 inch wide sink. All aerators must have a slightly low flow to calm our nanny government. This is stronger than the 1.3 GPM versions and the build quality is excellent. Fills a watering can or pot in a reasonable amount of time. Some faucets apply full pressure to the spray hose when you need power or a faster fill rate…

Whedon Products SU8C Super Swivel Dual Sprayer The dual swivel action of this faucet sprayer makes it the best I've had to deal with since starting my independent household in the 1970's. The water jet can be directed to wash the highest points of the sink. The water pressure that comes out of the end of this tool is very sufficient. In addition, most of the components are made of brass and the product is designed to last a very long time. This atomizer has really met all my expectations in…

This design is similar to the one I bought a few months ago but much easier to use. It doesn't have a lot of pivots so it's not as flexible, but it's MUCH easier to switch from jet to spray. The only problem - quite a big one - is that the water pressure is much lower with this design, but I can switch to the built-in sink spray if I need more pressure. The other had so much pressure that it cleaned everything perfectly, but mostly it spattered all over me while I was using it. It's a toss up…

After my plumber ruined my Ultra EuroJet sprayer, I looked for a replacement and decided to try the Whedon sprayer rather than buy another EuroJet. Whedon is good but having used both I prefer the EuroJet. The spray on Whedon is weaker in both 'modes' and I don't like its plasticity. But in truth it works quite well, only the EuroJet is a bit better in my opinion. This was confirmed when I decided to go ahead and purchase another Ultra EuroJet. I installed it the other day and was immediately…

Supposed to fit standard faucets. Apparently some Price-Pfister and Kohler fittings are not "standard". The product has a 55/64" internal thread and a 15/16" external thread. My polypropylene faucet has a tubular spout with 3/4"-27 male thread. There were no adapters in the kit, had to be purchased (Danco 10519). Unused male thread is visible but looks good. The black part is obviously plastic , and I also think the bright ring is around that.The spray angle is a circle about 4" in diameter and

This sprayer works well and is well built. I like what is made in the USA. It was very easy to install. The part that attaches to the mixer has both male and female threads. My complaint about this is a very weak current. I had an Ultra Euro Jet which I replaced with this one. It had twice the flow of this product. I had to replace it because it became so difficult to switch between jet and shower that I had to hold the faucet with one hand to prevent it from pulling it out of the sink while…

In those darkest days before Revain Prime, I probably spent about $100 on plastic sink aerators over the course of ten years. You will work for a while and then die. I just bought my 100th and was looking for a bullet attachment to give it more protection when I came across this Whedon. I looked at it and kept searching, but something got stuck in the corner of my memory, I couldn't remember its name, so I started banging back, back, back, back, back until I found it. And it said "Double Pivot…