Header banner
Revain logoHome Page
weiyingsi charging port with cable for electric ๐Ÿ”Œ smart self-balancing scooter (2-wire version) - efficient charging solution logo

WEIYINGSI Charging Port with Cable for Electric ๐Ÿ”Œ Smart Self-Balancing Scooter (2-Wire Version) - Efficient Charging Solution Review

3

ยท

Very good

Revainrating 4.5 out of 5ย ย 
Ratingย 
4.3
๐Ÿ›น Skates, Skateboards & Scooters, ๐Ÿฅ‹ Sports & Fitness

View on AmazonView on ะฏM

Media

(3)
img 1 attached to WEIYINGSI Charging Port with Cable for Electric ๐Ÿ”Œ Smart Self-Balancing Scooter (2-Wire Version) - Efficient Charging Solution
img 2 attached to WEIYINGSI Charging Port with Cable for Electric ๐Ÿ”Œ Smart Self-Balancing Scooter (2-Wire Version) - Efficient Charging Solution
img 3 attached to WEIYINGSI Charging Port with Cable for Electric ๐Ÿ”Œ Smart Self-Balancing Scooter (2-Wire Version) - Efficient Charging Solution

Description of WEIYINGSI Charging Port with Cable for Electric ๐Ÿ”Œ Smart Self-Balancing Scooter (2-Wire Version) - Efficient Charging Solution

If it doesn't work, just pick out the insert and change the black and red wire.It will work well !. The charging port with 2 wire / 2 pin connector, not 4 wires. Charging Port inner diameter: 0.36"(9.3mm),has 3 prongs as shown in the picture. Fit for 2-Wheel Stand Up Electric Smart Scooter Self-balancing Vehicle. Wire Gauge: AWG 24 /Outer diameter : 0.511 mm (0.0201 inch) /Cross section : 0.2047 mm2 /Resistance : 89.4 ฮฉ/Km /Normal current : 0.808 A /Max current : 0.921 A.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

As described, works fine.

Used to replace the charging socket on the Bird Air Scooter. Swapped and charged because the connectors are different. Very happy.

Pros
  • Sport
Cons
  • Drill Kit

Revainrating 3 out of 5

Works on a Razor 2.0 Self Balancing Hoverboard

It works on a Razor 2.0 Hoverboard just had to reconnect the cables and run had to reconnect the cables to connect it took it all about 30 minutes. Finished

Pros
  • Skates, Skateboards and Scooters
Cons
  • Out of fashion

Revainrating 5 out of 5

It took me 2 hours to remove the screws from the hoverboard but 5 minutes to screw it on!

I spent a lot of time loosening the screws on the hoverboard, because the screws were not loosened - they were so tight that when trying to loosen them + the shape of the screw head was round and my screwdriver turned in it. I practically drilled a hole in the screw with a drill and Easy-Out and pulled it out with great difficulty. However, once I took it out, this replacement took less than 5 minutes to install. And my hoverboard works like new again. Works perfect.

Pros
  • Sports and outdoor activities
Cons
  • There are problems