🔥 WINSINN 24V 5015 Dual Ball Bearing 50x15mm Blower Fan - High Speed Turbo Brushless (Pack of 4Pcs) Review

I've installed 2 of these so far, both in 3D printers. They have excellent airflow and are a real upgrade over the stock fans that came with the kit. The people who sell these fans support their products and have responded very quickly to a single fan issue. I will be buying more of these for future projects as this was exactly the product I needed. There are plans to install two fans on one of the printers soon, but they are so good you may need to take them a step back or print really fast…

Like others I had a Vicks cold humidifier and the fan on it failed after about a year. Instead of getting a new one ($45?) I tried this. This is the perfect physical shape, the plug works well, the polarity is correct. It took me about 10 minutes to swap out the old one - fairly easy if you have a medium Phillips screwdriver. It produces about 30% more fan noise than the original. And it doesn't wick away moisture (mist) completely. I think it emits more moisture at altitude, but instead of…

It seems like most people buy fans for their 3D printers, but it is typically used as an exhaust fan for humidifiers and aromatherapy devices. They don't last forever, especially when calcium builds up. But it's very easy to turn them off. Disassemble the base, remove the control board cover. It detaches from the circuit board and slides out of position. I had foam tape to dampen the vibration and you can put a few pieces in the same spots on the new fan. I carefully removed the tape from the…

Purchased to replace/upgrade the standard glow fan for the Anycubic Kossel Linear Plus. 100% is much stronger. Fairly quiet, no louder than standard servos. Cons: The connector was wired backwards to a stock Anycubic fan, so at first I thought I had a bunch of broken fans. The cable was too short to use the printer. Both bugs were easily fixed with a bit of soldering, but I'm deducting a star because the Trigorilla board isn't plug and play. The fan uses 26AWG 7-wire tinned copper wire. You'll…

The fan itself has a long enough wire to reach the motherboard from its hot-end position. I used this fan to replace the stock fan on my Ender 3. Plugs into the same port and works fine. it's about as loud as the old fan but whines less. I received 2 fans in the box which were significantly louder than the other 2 suggesting that quality control is a bit lacking. I was lucky enough to have a replacement fan that wasn't noisy and sounded damaged. Overall, you should be careful when purchasing…