Header banner
Revain logoHome Page
πŸ§ͺ winters stainless pressure internals: enhanced accuracy testing and inspection for pressure and vacuum systems logo

πŸ§ͺ Winters Stainless Pressure Internals: Enhanced Accuracy Testing and Inspection for Pressure and Vacuum Systems Review

3

Β·

Average

Revainrating 3.5 out of 5Β Β 
RatingΒ 
3.3
πŸŒ€ Pressure & Vacuum, πŸ” Test, Measure & Inspect

View on AmazonView on Π―M

Media

(1)
img 1 attached to πŸ§ͺ Winters Stainless Pressure Internals: Enhanced Accuracy Testing and Inspection for Pressure and Vacuum Systems

Description of πŸ§ͺ Winters Stainless Pressure Internals: Enhanced Accuracy Testing and Inspection for Pressure and Vacuum Systems

Brass wetted parts for measuring non-corrosive liquid and gas pressure. Circular dial is filled with glycerin and enclosed in a stainless steel 304 case for corrosion resistance. Measures pressure with single (psi) or dual scale (psi/kPa)/(psi/bar)/(Hg. vacuum/kPa)/(Hg. vacuum/bar). Display accuracy is + or - 2.5% of full scale value for the 1.5" (40 mm) and 2" (50 mm) gauges, and + or - 1.5% of full scale value for the 2.5" (63 mm) and 4" (100 mm) gauges. Lower mount or center back male connection with 1/8", 1/4", or 1/2" NPT rate with restricted orifice.

Reviews

Global ratings 3
  • 5
    1
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 4 out of 5

better than hardware store type

I think I've covered this before. That's pretty good, although the "full point" shifts a bit. The 4-inch version was better for reading in the dim light of a pumping station, but the flimsy, slender mounting pole didn't match the weight of this thing. Much better than the unsteamed shop junk, Jim.

Pros
  • price
Cons
  • little things

Revainrating 5 out of 5

Works perfectly. best in category Pressure gauge and vacuum gauge

Works great. Arrived on time, well packaged. I use it to measure the water pressure (and therefore height) of water in a water tank about 10 feet high. Because water pressure is low (less than 10 psi), gauges are generally sensitive to over-pressure, and a liquid-filled gauge will dampen any pressure spikes.

Pros
  • Nice packaging
Cons
  • Can't remember

Revainrating 1 out of 5

2. Sensor Upgrade---The sensor reads 1.0-1.5psi right out of the box. Low liquid level.

UPDATE: 2nd CAM *** Again, I can't fault Winters, they probably make good gauges. Blame Revain again, this time shipping in an unlined plastic envelope, shame on AMAZON! Arrow NOT ZERO, UPS EXCEEDS! Very disappointed that this liquid filled gauge comes in a small box in an unlined envelope which may have affected the accuracy. Too bad it doesn't have a zero balance, the liquid level is below normal and shows pressure when it doesn't. I'm wondering if any of their sensors are worth considering.

Pros
  • Sturdy construction
Cons
  • No automatic