WLJH 194 Led Bulb PC195 PC194 PC168 Car Dashboard Instrument Panel Bulbs 168 2825 T10 Led Twist Socket Locks Dash Lights Gauge Cluster Led Super Bright (Green Review

Great lights, they look stunning, they are dim but not to the extent of regular bulbs. but I would give it 9/10. Shipped faster than tracking says, don't expect to rely on this data.

Easy to install, they come with cord and bulbs so easier to replace but I like them, unfortunately they aren't dimmable so I can't use them at night dim but they work great no problems

likes the ease of change but not the brightness. I get a lot of light so they almost blind the driver at night. They will work well elsewhere, but not as well on the instrument cluster in a 2001 Toyota Camry.

I am ordering a 2005 Chevy Silverado. As the fit guide said, it fits. Well, that wasn't the case, and part of my fault is not realizing my headlights were soldered in and not twisted bulb style. However, I would give these flashlights 5 stars because of the function and the extreme brightness. I took them out of the bracket and soldered them directly to the board instead of sending them back. In my instrument cluster, they're almost too bright. If you need a bright backlight, they're super…

I installed them on a 1999 Tahoe dash. The bulb sockets fit the bulbs and holes, but they rotate further than necessary and don't touch the circuit board. I used factory lamp holders and it worked fine. All lights worked but 3 were brighter than the rest and I have hot spots (brighter light) in those places. The rest of the lamps are perfect. I will look into another brand and see if I can get the same color bulbs.

Used to replace old lightbulbs in my instrument cluster. Good brightness and good performance. Update: I've had them in my 02 Silverado for a little over a year and the entire right side has failed. All went out after about a week. LED bulbs should last much longer, especially since I don't drive them as my main vehicle. As others have said, the twist lock can go too far so you have to slide it back a bit for it to work. They were never blacked out, but that was okay. I will not buy another…

It took some time to get these lights but it was fine for shipping overseas. I am replacing the factory dashboards on my 1984 Chevrolet C10 pickup. Not only did these lights come with new sockets, they are also perfectly interchangeable with old sockets. They have a good 6V to 10V diode range. The amp draw is negligible, especially compared to factory tubes. They flash at voltages below 6V, so you can experience this with minimal lighting. The only thing to add is that they are polarized. If…

Fits 1990 Chevy Suburban with original dark old fashioned dashboard bulb lighting. At first I didn't understand that I need a T10 size for sensors. Aside from the gauges, there are T5 Seagate LEDs (AC Control, Courtesy, Dome, Dash, Vanity) that worked great. Like other reviewers I share concerns about the quality of the T10 LEDs compared to the newer T5s whose durability remains to be seen. However, they are easy to install, no problem with rotating the lamp base on the circuit board as others…

I bought these LED bulbs for my 2000 Toyota Camry. Installation was very easy. The initial brightness was stellar. I have reason to say initially. Last night 11/24/2019 my dashboard did not light up at all. The reason is that all the LEDs fell out of the lamp housing. My car needed 5 of these bulbs and they come in a pack of 6. I took out all the bulbs and compared them to the unused one. As you can see, the one on the left still has green LEDs on the top of the lamp holder, the one on the…