🔧 Wostore Double Flaring Tool Kit: 7 Dies Automotive Line Tubing Cutter with Replacement Blade and Remear – 3/16"-5/8" Sizes Included Review

High performance at a low price. I've tried a dozen different flair kits and this was the "most affordable". Worth the cost to ensure you get the 'perfect flair'. However, 4lifetimelines' copper-nickel material is a little soft, so don't always make it fully concentric in the mold. WATCH a video about it. Anvils are important and I didn't realize it at first.

First of all, I'm new to cane torches. The set appears to be high quality and complete. I've only used it to flare small diameter brake lines. I used it to double Ni-Cop tubes and it worked fine. I've tried flaring stainless steel tubing and it hasn't flared at all, but I've found flaring stainless steel to be very difficult, especially if you're inexperienced. I haven't tried just steel tubing.

I used this to flare a 3/8" aluminum fuel line. This is the second largest bell for this instrument. Almost all your strength goes into expanding a 3/8" aluminum rod. For copper 1/2" good luck. This tool should be a little more "heavy duty". If you're diligent, though, take your time , make sure the cut is burr free and the cut is straight and even THEN the torch will not leak like my first flash did.Be sure to read the instructions, the instructions contain very important information.