Xislet 3-Wire Tail Light Power Harness: Ultimate Compatibility with 2015-2021 Polaris RZR 900 🔌 1000 XP Turbo – Light Whip, Brake Light, License Plate Light – Efficient 3 Wire Connector Review

Perfect fit, tight fit. Standard wires do not need to be modified. Definitely time-saving and clean installation of additional accessories.

Good product. I bought two of these, one will be used on a 2015 XP4 and the other will be used on a 2021 XP1000. Can I use this to install a third FIERY brake light?

Multi-pin connectors will not mate with the 2019 Turbo S taillight harness plug-in mini-harness, the Polaris harness has rectangular multi-pin connectors.

Bought some of them. There was good, there was bad. Poor job crimping the terminal as the wires are easily pulled out of the connector. I had to disassemble the connector and redo some terminals.

Installed well, results in only 3 wires instead of all 4. On my 2020 model, the 4th wire goes to the factory headlight ground. The factory headlights will not work if this 3-wire connector is used. It's almost impossible to find anyone selling a 4-wire version, but after much searching I succeeded.

RZR owners please read. You need to connect it directly to your taillight and THEN plug the wire harness into this socket. If you use this further down the suspension you lose the ability to use your tail light. It worked great. To be clear these wires were done correctly, they fit fine but the rzr electronics don't work as a simple relay/fuse/simple install. Before you buy, test your plug with a regular plug tester or a flashlight. No stars, these are great devices, they just don't work in my…