Xprite Amber/White 6 LED Emergency Strobe Lights Kit - Enhanced Safety for Off-Road Vehicles, ATV Trucks, Cars - 4Pcs Review

Great for the price when supplied with screws or bolts for attachment. The second set I ordered came with the necessary screws, the lights are perfect but not fully waterproof. Will definitely buy again

I have used these headlights on other cars and their brightness makes them very valuable. I'm definitely pleased with how easy they are to install. Thank you for your attention.

The product list mentions selectable flash patterns, but DOES NOT include a controller and there is no information to get one. It's just the headlights! If I had known that, I would not have made the purchase.

Probably the best I can say is this. After seeing these lights installed, a friend bought 2 sets (one for him and one for his dad) and is planning on ordering a third set! My Whelen light bar went out while plowing and those 4 LEDs were bright enough for me to SAFELY continue plowing.

About three months later two of my lamps got water and stopped working properly. A year later, three more lightbulbs stopped working because of water ingress. While they are bright and do what I need, constantly replacing them is no good.

Incredible 3 out of 4 bulbs leaking, called customer service and gave me a number after I made a claim Sent photos with claim number and not emailed a replacement for over a month ! Don't waste your money! Lesson learned and this company is based in my home state of California

I replaced several strobe lights on my truck with older technology that stick out almost 1 1/4 inches off the ground. more expensive, brighter and offer two colors compared to the single color older lamp. Luckily I tested the blocks before installing them, one block was defective. The seller quickly sent a replacement unit and the job was done. I am still waiting for a return authorization so that I can return the defective unit. I have attached a photo with the new device on the left and the…

These lights have 5 cables. Red, black, yellow, white and gray. Red is positive, black is negative/ground, yellow is for pattern change. Gray + White is for syncing (which most standalone lights don't usually have. So they connect the gray on one light to the white on the other to sync their flash patterns. Make sure you connect them before powering up You can continue chain for every 4 bulbs (or more if compatible. Just keep painting the wires grey+white+grey+white. This also includes rubber…