🔔 Bell and Gossett 103251 NRF-22 Cast Iron Wet Rotor Circulator Pump by Bell and Gossett Review

I ordered this to replace my existing water circulation pump at home. An identical model was installed when the house was built in 1998, so the first has lasted around 15 years in continuous 24/7 use. I was happy to find an identical model number on the Revain from multiple vendors. Paid about $60. It was a perfect replacement for 1998, which was very important. Upon inspecting the OLD ONE I removed, it turned out that the plastic propeller fins were broken inside. The engine was still running,

Don't call a plumber unless you want his truck to pay for it. Close the main water tap, relieve the pressure by opening the taps. Disconnect the power cord from the pump. Hold a bucket of water under you to collect water in the lines. Use a wrench and socket to loosen the bracket screws. Before removing the pump, look at the water direction arrow. The pumping oscillation is weakened. After removing, open the electrical cover, loosen the cable screws and pull out the power cord. Connect the…

So some of these reviews contain incorrect information. No, you can't just take the horsepower number and assume you have the right pump somewhere. IF your old pump is the right size (and that's a big IF if it was installed by a plumber and not a good boilermaker), this pump is roughly equivalent to a TACO 007-F5 (the most common domestic circulating pump in the US). , according to TACO) or a Grundfoss UPS15-58FC (probably #2) at medium speed. B&G performance is slightly better than TACO or…