🚀 RocketBus 5-Pack Small Tint Applicator Rubber Squeegee for Car Window Film Bubble Removal Review

Use these to extrude a resin printer reservoir. Great for that. They don't scratch the FEP, and the corners in them go into the corners of the reservoir.

I bought this product on the recommendation of some other 3D printer enthusiasts for use in cleaning resin printer baths. Similar to squeezing vinyl bubbles, this device gently pushes the resin over the surface of the FEP film without damaging the film or leaving marks. An absolute must for cleaning a resin printer, this unit works even better than I had hoped.

If you're reading this because someone recommended them for your printer, just buy them. They will work great for you. I bought these on recommendation to use to remove resin from the FEP film in my SLA printer's resin tank. I have to say I'm impressed! They're great for this purpose, they're also great for mixing resin between prints and for cleanup! No small feat for tools that are regularly dipped in photoreactive resin. I will recommend them to anyone I know with an SLA printer.

Excellent for cleaning the bottom of a FEP/nFEP resin 3D printer without scratching the film (on Anycubic, Elegoo or EPAX printers , to name just a few). ). It took some scrapers to remove the skin, but with scissors it wasn't much of a problem. The material is more like rubber than silicone, but for my purposes it doesn't matter, and much more effective than using the included hard plastic scraper that came with the printer, with less risk of damaging the FEP/nFEP film. There's enough in this…