🔋 Bay Marine Supply Busbar – 12-Point Power Distribution Block (240A Rating) – #8 Terminal Screws & 1/4" Stud – Black Bus Bar with Free Electrical Grease Review

The plastic cover has to snap in place, fits freely, only holds the rubber cap on the end of the wire, which isn't very good either.

Just what I need. Simplified my vehicle wiring project and future additions will have a clean, central place to ground directly from the battery.

A little clunky, more than expected. Haven't used them yet as they are a bit bulky. Overall they are durable and given the right place and application I'm sure they will be a good product.

Does what it is advertised to do and what it was made for The bad thing is you have to connect the battery with the cover on. The cover can't go on after that (wish I had) but I won't give a bad review just for that. it works as it should.

I had some wires wrapped in tape to ground various relays or activate switched power supplies. I bought them so I could have a distribution block where the new ones could get their own DC, switching, or ground wires. I liked the cover that protects the main power cable and the cover for 12 screws. Well built.

I won't fill in the "Easy to install" ratings because, okay. It's literally two screws how heavy is that. The reason for the 2 stars overall is the cap. It doesn't stick to anything, it rests on the main power cord and that's it. He flops. There should be a fastener so you can tighten it.

I had taped a few wires to ground various relays or activate switched power supplies. I bought them to have a distribution block where newbies can get their own DC, switching, or ground wires. I liked the cover that protects the main power cable and the cover for 12 screws. Well built.

It's literally two screws how heavy is that. The reason for the 2 stars total is the cap. It doesn't stick to anything, it rests on the main power cord and that's it. He flops. There should be a clasp so you can tighten it.

They are built. Much stronger and more powerful than I expected. The processing is rough. I installed it under my Jeep's dash to connect all the power and ground wires. I added some threadlock to each clamp screw for safety, but the few I didn't have wouldn't loosen from the vibration. The thickness of the stem and terminal ensures they can handle the heavy load of the amp.