🔦 Bevel Engineering Premium LED Upgrade Kit for Polaris Ranger RZR General - H13/9008 Headlight Bulb Kit (2-Pack) - Low and High Beam Lamp Set Review

Much better than stock lights. Brighter than white, installation was easy, and visibility is much better. Installed in 2019 Polaris Ranger Crew.

What an amazing difference when you switch from the standard bulbs on my RZR 1000 to these LED bulbs! Makes everything much brighter and blends better with the light bar.

High and low beams were swapped but all you had to do was rotate the connector 180 degrees. These LED lights are easy to install and very bright compared to traditional bulbs. They are great for night driving.

Much brighter than standard halogen. The only drawback is the loose fit. I used the red seals from stock bulbs like the others and they still wobble a bit. All in all a worthwhile purchase. May use HIDs in the future but will use them for now.

I installed these bulbs on my 2015 RZR 900 with no problems, they fit right in, they fit snugly in the headlamp housing and seem to seal well, much brighter than stock. Make sure you attach the extra slack on the wires to the frame, otherwise they might get caught on something. The only criticism is that the high and low beams are pushed back.

These LED bulbs worked great on my 2019 Polaris XP 900 Premium Silver, FYI. problem and now they fit exactly like they should. I also found that you may need to rotate and reinstall the LED bulbs to get them to work properly for low and high beam. They are very bright with a white beam that matches my LED grid light I have installed on the roof. I am very satisfied and can highly recommend them.

Bright light and a nice improvement over factory bulbs. Two things to note. 1) They fit my general's torso fairly loosely. I had to remove the I-ring from the factory bulbs and slip it over the silicone grommets that came with the kit to ensure a decent seal. 2) They were connected backwards. Low beam was high beam and high beam was low beam. I had to remove the pins from the factory connector and swap them. In case anyone else has this problem, the yellow and green wires are high and low and…